Description
P1 Interface Bridge – RJ45 Ethernet (and Wi-Fi)
This is the ethernet version of P1IB.
P1IB-eth comes with
- P1-cable (RJ12, crossover cable), shipped with 0.5m length. If you want a longer, 1.5m, please write a message during checkout.
- RJ12 port for the P1 connection to your power meter.
- RJ45 ethernet port for network/internet connection
- Wi-Fi
- USB-C port (normally not used)
Note. P1IB-eth is powered by the P1 connection. There is no need to supply power via USB.
Note. P1IB-eth does NOT work with RJ45 HAN-port power meters. The RJ45 port must only be used for a ethernet connection.
Features
- Fully configurable via web UI.
- RJ45 Ethernet connection
- WiFi
- DHCP/static ip
- MQTT settings
- And lots more…
- Dashboard in web UI with realtime updated graphs for the majority of measurement points from the power meter.
- Supports both protocols that the Swedish meters use at this moment:
- DLMS/COSEM AXDR/HDLC Mode E (Aidon).
- DLMS/COSEM ASCII Mode D (the other ones).
- MQTT support.
- Automatic sensor registration for Home Assistant (MQTT Auto Discovery).
- Supports OTA firmware update via web ui (official builds fetched from p1ib github repo).
- Webservice with JSON response of meter data.
- Reduced data mode
- Logging/debug through UDP to a remote computer and/or USB serial.
- P1IB does not require any internet connection (with the exception for over-the-air firmware updates).
More information and screenshots @ https://remne.tech/p1ib-eth/
Documentation and installation instructions @ https://github.com/remne/p1ib
